Table of Contents
Advertisement
Available languages
Available languages
In the State of Massachusetts, the following installation instructions apply:
■
Installations and repairs must be performed by a qualified or licensed contractor, plumber, or gasfitter qualified or licensed by
the State of Massachusetts.
■
If using a ball valve, it shall be a T-handle type.
■
A flexible gas connector, when used, must not exceed 3 feet.
Anti-Tip
Bracket
Range Foot
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Tools needed
■
Tape measure
■
#2 Phillips screwdriver
¹⁄₈" x 4¼" flat-blade
■
screwdriver
■
Level
■
Drill
■
Wrench or pliers
■
Pipe wrench
■
Adjustable wrench or
⁵⁄₈" wrench
³⁄₈" drive ratchet
■
¹⁄₈" drill bit
■
¹⁵⁄₁₆" combination wrench
■
¹⁄₄", ³⁄₈", ⁵⁄₁₆" nut drivers
■
A child or adult can tip the range and be killed.
Install anti-tip bracket to floor or wall per installation instructions.
Slide range back so rear range foot is engaged in the slot of the anti-tip bracket.
Re-engage anti-tip bracket if range is moved.
Do not operate range without anti-tip bracket installed and engaged.
Failure to follow these instructions can result in death or serious burns to children and adults.
To verify the anti-tip bracket is installed and engaged:
• Slide range forward.
• Look for the anti-tip bracket securely attached to floor or wall.
• Slide range back so rear range foot is under anti-tip bracket.
• See installation instructions for details.
INSTALLATION REQUIREMENTS
Tools and Parts
³⁄₁₆" carbide tip masonry bit
■
■
Marker or pencil
■
Pipe-joint compound
resistant to LP gas
■
Noncorrosive leak-detection
solution
■
Tubing cutter
For LP/Natural Gas
Conversions
■
Adjustable wrench
■
½" deep-well socket
■
7 mm nut driver
■
Masking tape
WARNING
Tip Over Hazard
Parts supplied
Check that all parts are included.
■
Anti-tip bracket kit
A
A. Anti-tip bracket
B. #8-18 x 1" Phillips head screws (4)
NOTE: Anti-tip bracket must be securely mounted to subfloor.
Thickness of flooring may require longer screws to anchor
bracket to subfloor. Longer screws are available from your local
hardware store. See "Install Anti-Tip Bracket" section.
■
Gas pressure regulator
■
Burner grates
■
Burner bases and burner caps
■
Griddle drip tray (on griddle models)
■
LP orifice package (W10393336)
■
Conversion label (8114P522-60)
NOTE: The cooktop is manufactured for use with Natural gas. To
convert to LP gas, see the "Gas Conversions" section.
B
3
Advertisement
Table of Contents
