Common Operations - Clarion FZ409E Owner's Manual

Common Operations

Security code
This unit can deter theft by checking registered
security code if security code is registered. The
security code is registered in the Adjustment
mode "CODE" item.
For first time installation, no security code is re-
quired.
If security code is registered, changing or discon-
necting the vehicle battery will cause the security
code input to be requested for activation. "INPUT
0000" will be displayed and "0000" is blinking.
1. Slide along [ ] slider or touch [
to choose 1~6 to input the security code.
∗ After input first digit, "0000" will stop blinking.
2. Touch [ ] key to go on with the next digit.
3. Touch [ ] key to confirm during finish input
the 4 security code.
4. Successful password input will power ON the
unit.
CAUTION
!
If entered code is wrong, "----" will be displayed
for a given period during which no operation
can be performed. After the locking peroid,
"INPUT 0000" will be displayed again. For
mistakes less than 7 times, the locking time
will be 15 seconds; from 7
locking time will be 15 minutes.
Downloaded from Caradio-Manual.com Manuals
] / [ ] key
time onwards, the
th
Adjustment Mode
1. Touch the [ ] key to switch to ADJ menu.
2. Select "SETTING" in the menu to enter setting
mode.
3. Each time you slide along the [
[ ] / [ ] key, the setting mode changed as
following order:
"DISP BRIGHT"
"SCREEN SAVER"
"SCROLL SPEED"
"BLINKING LED"
"TEL SWITCH"
∗ If no operation is performed for more than 10
seconds, ADJ mode is cancelled and the display
returns to the previous mode.
Setting the display brightness
You can adjust the display brightness to match
the angle of installation of the unit.
∗ The factory default setting is "5".
( Adjustment level: 1 to 8 )
Select "DISP BRIGHT".
3 - 1 .
Touch [ ] key to enter detail setting stage.
3 - 2 .
Slide along [
3 - 3 .
key to adjust the value.
Notes:
If both the dimmer and the car's illumination are
turned on, "ILLUMI ON" and the adjustment value
will be displayed. If the dimmer is turned on and
the car's illumination is turned off, "ILLUMI OFF"
and the adjustment value will be displayed.
If the dimmer is turned off, only the adjustment value
will be displayed.
The display brightness level setting during dimmer
and car's illumination are turned on has indepen-
dent adjustment value.
Setting the beep
∗ The factory default setting is "ON".
Select "BEEP".
3 - 1 .
Touch [ ] key to enter detail setting stage.
3 - 2 .
Touch the [ ] / [
3 - 3 .
"OFF".
] or touch
"BEEP" "CODE"
"AUTO SCROLL"
"DIMMER"
"AMP CANCEL"
"SYSTEM CHECK"
] slider or touch [ ] / [
] key to select "ON" or
FZ409E
]
29