Superior MHW36R Installation And Operation Instructions Manual page 16

operaTion and MainTenanCe gUidelineS
Door Removal
1. Fold doors (fully open) and press up on
upper door spring clip until top pin is free
of the spring clip (see Figure 26). Tip door
toward middle of fireplace opening and lift
door out of the lower pivot hole.
2. Repeat step 1 for remaining door.
Fold Door
and Slide
Top Pins
Into Track
Figure 26 - Removing/Installing Bi-Fold
Installing Glass Doors
1. With bi-fold doors completely folded, insert
bottom pivot pin into pivot hole located
near bottom corner of front face opening
and swing door to vertical position making
sure top pins slide into door track. Door is
installed when top door pin snaps into spring
clip (see Figure 26).
2. Repeat step 1 for remaining door.
If you find the doors do not close properly or
do not appear level or straight, proceed with
section on door adjustment.
Door Adjustment
Remove doors and slightly loosen lower pivot
clips and upper spring clips. Replace doors
and fully close them. Use 1/8" shims (any
material) to level doors. Once proper setting
is achieved, carefully open doors enough so
that you can access spring clips with a phillips
screwdriver. Tighten screws. See Figure 27.
16
Insert Pin
into Spring
Clip
Insert
Bottom
Pivot Pin
into Hole
Pivot
Hole
Doors
SuperiorFireplaces.US.com
Continued
Spring
Clip
Figure 27 - Adjusting Bi-Fold Doors
CLEANING GLASS
Clean the glass with any commercial glass
cleaner or soap and water. Do not use any
abrasive material to clean glass. Do not clean
glass with any cool water if glass is still hot
from fire and smoke.
DAMPER OPERATION
The damper handle, which opens and closes
damper blade, is located inside firebox at cen-
ter towards back wall. Pushing handle back
in keyway slot will free damper blade to au-
tomatically open. To close, reach in and push
handle back into keyhole slot then pull down
and forward to lock it in place (see Figure 28).
Damper is not designed to be airtight. A small
gap around damper blade is normal.
Damper
Weight
Closed Damper
Figure 28 - Damper Operation
WARNING: Risk of fire!
Always replace grate with In-
novative Hearth Products part
number 11116 grate only. This
grate has been designed to keep
the operation of your fireplace
safe and efficient.
Damper
Handle
Open Damper
127312-01B