Connecting To Local Nodes - Yaesu FTM-100DR Instruction Manual

Connecting to local nodes

1
Rotate the DIAL to set the operating band to the
frequency of the desired local node.
2
Press and hold
[ X ] flashes on the left side of the frequency display.
When a local node is found, [ X ] is lit solid, and the node name and city name
appear on the upper part of the screen.
Tip Depending on the connection status, the screen will show one of four display patterns.
(1)
Connected to the local node, but unable to connect
to Internet nodes or rooms (never before established
connection to Internet nodes or rooms)
(2)
Connected to the local node, but unable to connect
to Internet nodes or rooms (previously succeeded in
establishing connection to Internet nodes or rooms)
(3)
Connected to the local node, successfully connected
to an Internet node or room (the Internet node or
room is the same as the one used before)
(4)
Connected to the local node, successfully connected
to an Internet node or room (the Internet node or
room is different from the one used before)
When is displayed, rotate the DIAL. Call signs
of nodes and rooms on the Internet you previously
connected to flash.
While [ X ] is flashing, briefly press the
Tip
establish connection to the local node.
When any local node cannot be found, [ X ] will
Tip
disappear in five minutes.
Tip When the detected local node is a repeater station, [
[ R ] ] appears below [ X ].
Connecting to a Faraway Station Using WIRES-X
for over one second.
key to re-
9