Replacing Vacuum Bag And Filters - Simplicity Moxie Owner's Manual

Replacing the vacuum bag
Dust cover
latch
• Turn canister off, remove
hose, and open the dust
cover.
NOTE: The "check bag" light is located on the power handle and will light up when either the bag is
full or when a clog is detected in the machine. If upon inspection the bag is not full, please
inspect the hose or wand for a clog and remove. The check bag light may illuminate when
cleaning with on-board tools. Should this occur, continue cleaning normally.
Replacing the secondary filter
• Unplug canister and remove the hose.
• Open the dust cover and locate the
secondary filter behind the bag.
• Remove filter case and discard used
filter.
• Insert new filter into filter case and
re-insert case.
• Close the dust cover.
Replacing the HEPA filter
• Unplug canister and remove HEPA
filter cover.
• Remove and discard used HEPA filter.
• Insert new HEPA filter.
• Press the "reset filter button" located
next to the HEPA filter.
• Reinsert HEPA filter cover onto the
machine.
NOTE: Change the HEPA filter when the "service filter" light is illuminated on the power handle.
Genuine HEPA filters cannot be washed or re-used.

Replacing Vacuum Bag and Filters

Vacuum bag
holder
• Pull the tab on the
cardboard bag collar which
closes the bag while removing
it from the bag holder.
• Do not re-use vacuum bag.
Secondary
filter
HEPA filter cover latch
5
Bag collar
• The dust cover will not close
without a bag in the unit
or if the bag is not inserted
properly.
Dust cover
lid
Secondary
filter
Filter
case
HEPA filter
cover
HEPA filter
Reset
Button