Installing The Screen Guard - Symbol iPOS 3100 Product Reference Manual

iPOS 3100 Product Reference Guide

Installing the Screen Guard

The screen guard protects the iPOS 3100's screen from typical wear such as scratches and
spills. Replace the screen guard when excessive scratches are visible or if a liquid is spilled
on the screen. This maintenance extends the operation of the iPOS 3100.
To install the screen guard onto the iPOS 3100:
1. Disconnect power from the iPOS 3100.
2. Clean the surface of the terminal and touchscreen using a cloth dampened with
non-abrasive glass cleaner. Do not spray liquid directly onto the terminal. Wait
until the terminal and glass are completely dry.
3. On the back of the screen guard, remove the paper adhesive guard.
Figure 1-4. Removing Adhesive from Screen Guard
4. Place the adhesive side down onto the graphical screen overlay, carefully aligning
the edges. Apply gentle pressure to the screen guard to ensure proper adhesion.
The screen guard can be removed and repositioned in case of misalignment.
1-6