Table of Contents
Advertisement
P P T
Calibrating the Screen
The first time you start your PPT 2700 (and whenever the terminal
is cold-booted) the calibration screen appears. This section
describes how to calibrate your PPT 2700 so the cursor on the touch
screen aligns with the tip of your stylus.
Note:
If your PPT 2700 unit came loaded with another soft-
ware application, the calibration screen may not appear.
To calibrate your PPT 2700:
1. If necessary, adjust the contrast on the PPT 2700 so the screen
is clear and readable. See Controlling the Contrast/Backlight
on page 9 for instructions.
2. Remove the stylus from its storage silo on the back of the PPT
2700.
3. Tap the center of each target that appears on the screen with
the tip of the stylus.
2 7 0 0
Tap the center of the target with the
stylus. Repeat as the target moves
around the screen.
8
S e r i e s
Advertisement
Table of Contents
