Zanussi ZWG 680P User Manual page 23

Fault code and malfunction
The light of button 6 flashes
and the light 7.3 illuminates:
Door open
The appliance does not start or stops during operation
without any visible alarm.
Malfunction
The appliance does not start:
The appliance fills then emp-
ties immediately:
The appliance does not empty
and/or does not spin:
There is water on the floor:
Downloaded From WashingMachine-Manual.com Manuals
The door has not been closed or is not closed properly.
• Close firmly the door.
The plug is not properly inserted in the power socket.
• Insert the plug into the power socket.
There is no power at the socket.
• Please check your domestic electrical installation.
The main fuse has blown.
• Replace the fuse.
The programme selector dial is not correctly positioned and the button 6 has not been
pressed.
• Please turn the selector dial and press the button 6 again.
The delay start has been selected.
• If the laundry are to be washed immediately, cancel the delay start.
The end of the drain hose is too low.
• Refer to paragraph in "Water drainage" in chapter "Installation".
An option or a programme that ends with the water still in the tub or a that eliminates
all the spinning phases has been selected.
• Select the draining or spinning programme.
The laundry is not evenly distributed in the drum.
• Redistribute the laundry.
Too much detergent or unsuitable detergent (creates too much foam) has been used.
• Reduce the detergent quantity or use another one.
Check whether there are any leaks from one of the inlet hose fittings. It is not always
easy to see this as the water runs down the hose; check to see if it is damp.
• Check the water inlet hose connection.
The drain or inlet hose is damaged.
• Replace it with a new one.
Possible cause / Solution
Before contacting your local Service Centre, please carry
out the checks listed below.
Possible cause / Solution
23