Operation; Removing Nails; Loading The Nailer - Makita GN900 Instruction Manual

Installing the hook
1
009457
The hook is convenient for hanging the tool temporarily.
The hook can be set in two positions according to where
the tool will be hung.
To change the hook position, contract it at its foot by
pushing in from both sides and shift to another position.
ASSEMBLY
CAUTION:
Always remove the fuel cell and the battery
•
cartridge.

Loading the nailer

009442
Insert a strip of nails into the slit in the rear of the
magazine.
009452
Pull the Pusher Lever to the rear of the Magazine and
return it to the end of the strip gently.
1. Hook
9
011695
Load nails so that they get parallel to the driver guide.

Removing nails

009453
Pull the pusher lever and push the pusher button to
release the nail supporter, and then return the pusher
lever to the top pushing the pusher button.
Slide the nails toward the rear of the magazine and
remove them out.

OPERATION

WARNING:
Do not touch around the exhaust vent. The
•
surface will be so hot during or after an operation.
Touching around the exhaust vent may cause
burns or injuries.
CAUTION:
Make sure all safety systems are in working order
•
before operation.
009454
1. To drive a nail, place the contact element against
the workpiece.
The fan motor is activated, fuel gas is injected into
combustion chamber and mixed with air by the fan.
1. Pusher button
1