1. Manuals
  2. Brands
  3. Makita Manuals
  4. Nail Gun
  5. GN900
  6. Instruction manual

Makita GN900 Instruction Manual

Cordless clipped head framing nailer
Hide thumbs Also See for GN900:
Table of Contents

Advertisement

Quick Links

Download this manual See also: Instruction Manual
INSTRUCTION MANUAL
Cordless Clipped Head Framing
Nailer
GN900
009440
IMPORTANT: Read Before Using.
1

Advertisement

Table of Contents
loading

Related Manuals for Makita GN900

Summary of Contents for Makita GN900

  • Page 1 INSTRUCTION MANUAL Cordless Clipped Head Framing Nailer GN900 009440 IMPORTANT: Read Before Using.

  • Page 2: Specifications

    ENGLISH (Original instructions) SPECIFICATIONS Model GN900 Nail length X Shank diameter Nail L :50 mm - 90 mm d : 2.9 mm - 3.3 mm Nail capacity 40 nails (1strip) Nail collation angle (degree) Figure of nail head Clipped Dimensions (L X W X H)

  • Page 3: General Power Tool Safety Warnings

    Keep work area clean and well lit. Cluttered or Makita Corporation responsible dark areas invite accidents. manufacturer declare that the following Makita Do not operate power tools in explosive machine(s): atmospheres, such as in the presence of Designation of Machine: flammable liquids, gases or dust.
  • Page 4 under the influence of drugs, alcohol or power tool repaired before use. Many accidents medication. A moment of inattention while are caused by poorly maintained power tools. operating power tools may result in serious 22. Keep cutting tools sharp and clean. Properly personal injury.
  • Page 5 Face shield Power source Use the tool only with the Makita genuine fuel cell. • Do not touch liquid gas sprayed out of the fuel cell. • Contact with it may cause injury.
  • Page 6 Wipe off all dust • whether it contains fasteners or not. from the parts. Do not rush the job or force the tool. Handle the Ask Makita authorized service center for periodical • • tool carefully. inspection of the tool.

  • Page 7: Functional Description

    Do not incinerate the battery cartridge even if FUNCTIONAL DESCRIPTION it is severely damaged or is completely worn out. The battery cartridge can explode in a fire. Be careful not to drop or strike battery. CAUTION: Do not use a damaged battery. Always be sure to remove the fuel cell, the battery •...

  • Page 8: Adjusting The Nailing Depth

    Detach the cap (in case the metering valve is provided with the cap). 009450 Insert the jet nozzle into the small hole of the adapter properly. 009446 Push in the front edge. 009451 Put the fuel cover over the metering valve and push it 009447 Push in the rear edge until it seats.

  • Page 9: Operation

    Installing the hook 1. Hook 011695 Load nails so that they get parallel to the driver guide. 009457 The hook is convenient for hanging the tool temporarily. Removing nails The hook can be set in two positions according to where the tool will be hung.

  • Page 10: Cleaning The Air Filter

    At the end of daily work, conduct an end-of-workday routine. These simple steps are based on maintaining the safety 009460 and performance of Makita Cordless Clipped Head Loosen the (2) magazine mounting screws with Framing Nailer the hex wrench. Before leaving the work site: Remove the battery cartridge and store in a tool- carrying case.

  • Page 11: Optional Accessories

    Only use accessory or attachment for its stated purpose. If you need any assistance for more details regarding these accessories, ask your local Makita Service Center. Nails • Safety goggles • Fuel cell •...
  • Page 12 Makita Corporation Anjo, Aichi, Japan www.makita.com 884862E228...

Table of Contents