Mounting Of Wire For Glass Doors; Readjustment Of Wire - Bang & Olufsen BeoSound 3000 2671 Service Manual

5.12 Repair tips, English

Mounting of wire for glass doors

Readjustment of wire

- Turn the wire pulley G clockwise until it stops. (Closed door position).
- Turn the wheel H in click position.
- Mount the wire in the wire pulley H (the end with the heavy spring).
- Run the wire in the second innermost groove of the wire pulley H (underneath the
pulley), up around the uppermost pulleys (I, J, K and L) and down around the
lowermost pulleys (M, N, and O).
- Turn the pulley G anticlockwise.
- Fasten the wire in the pulley H.
- Mount the wire on pulley P and turn pulley G to check that everything is OK.
- Turn the pulley G such that the centre of the pulleys G and H is fl ush with the
upper edge of the tower X.
- Push the wire clamping clip towards the centre and tighten (not too tight).
L
I
X
H
G
P
M
K
J
O
N