Roland M-5000 Reference Manual page 208

M-48 Control
OVERVIEW Tab
This lets you list source levels and make group mixes.
Turning <ON FADER> on lets you use the M-5000's faders to work
with the source levels.
SOURCE OVERVIEW
SOURCE LEVEL
This resets the source level/pan settings to the
following values.
5 TO AUX: ON
RESET
5 PAN: C
5 LEVEL: -Inf dB
When this is on, you can use the faders to
manipulate the source levels.
ON FADER
The ON FADER feature is not applied to isolated
banks or the assignable fader section.
SOURCE OVERVIEW This displays meters and levels for the source.
GROUP MIX
This resets the group mix to the following values.
5 VOLUME: 0.0dB
5 PAN: C
5 REVERB SEND: -Inf dB
5 HI GAIN: 0.0dB
RESET
5 MID GAIN: 0.0dB
5 MID FREQ: 1.00kHz
5 LO GAIN: 0.0dB
5 SOLO: OFF
REVERB ON Reverb on/off
AUX IN
M-48 [AUX IN] knob
AMB M-48 [AMBIENT MIC] knob
LINE OUT M-48 LINE OUT [VOLUME] knob
BASS M-48 [BASS] knob
TREBLE M-48 [TREBLE] knob
LIMITER M-48 [LIMITER] knob
VOLUME M-48 PHONES [VOLUME] knob
LO G
LO GAIN for group EQ
MID F EQ MID FREQ for group EQ
MID G EQ MID GAIN for group EQ
HI G
EQ HI GAIN for group EQ
REVERB Group REVERB SEND
PAN Group PAN
VOLUME
Group VOLUME
You use the parameter area to work with the parameter selected
using GROUP MIX.
208
Parameter area
SOURCE LEV/PAN Tab
Here you make LEVEL, PAN, and TO AUX settings for sources 1
through 40, and specify assignments to groups.
SOURCE OVERVIEW
Parameter area
This resets the source level/pan settings to the
following values.
5 TO AUX: ON
RESET
5 PAN: C
5 LEVEL: -Inf dB
When this is on, you can use the faders to
manipulate the source levels.
You use <SOURCE OVERVIEW> to select the range
to work with in the parameter area.
ON FADER
The ON FADER feature is not applied to isolated
banks or the assignable fader section.
This displays meters and levels for the source.
SOURCE OVERVIEW
Tap this to select the range to work with in the
parameter area.
You perform the following operations in the parameter area.
Group selection PAN switch
Meter Source input level
PAN Source panning
This switches source panning in the following
sequence.
5 C
PAN switch
5 L63
5 R63
This displays a popover for assigning the source
Group selection
to a group.
LEVEL Source level
When this is on, the post-fader signal is sent to
AUX.
TO AUX
Pressing and holding this sets <LEVEL> to 0.0 dB.
Meter