Connect The Cables - Planar SD2421W User Manual

Connect the cables

The SD2421W unit comes with one 6-foot DVI cable and one 12-foot DVI cable.
1. Plug one end of the 6-foot DVI cable into the primary port of the dual-
channel DVI graphics card. Plug the other end into the bottom monitor of
the SD2421W unit.
2. Plug one end of the 12-foot DVI cable into the other graphics card and
then plug the other end into the top monitor of the SD2421W unit.
The two monitors must be connected with an off-the-shelf
video cable to comply with FCC regulations. Ferrite-core
interface cables are provided. This device will not be in
compliance with FCC regulations when a non-ferrite-core
video cable is used.
User's Guide | 7