Table of Contents
Advertisement
Connect the cables
The SD2320W unit comes with one 6-foot DVI cable, one 12-foot DVI cable,
and one 14-inch DVI cable.
1.
Plug one end of the 6-foot DVI
cable into the primary port of
the dual-channel DVI graphics
card. Plug the other end into
the bottom monitor of the
SD2320W unit.
2.
Plug one end of the 14-inch DVI
cable into the secondary output
of the dual-channel graphics
card. Plug the other end into
the input port (labeled "IN") of
the mirror-flip PCI card.
3.
Plug one end of the 12-foot DVI cable
into the output port of the mirror-flip
PCI card (labeled "OUT"). Plug the
other end into the top monitor of
the SD2320W unit.
The two monitors must be connected with an off-the-shelf video
cable to comply with FCC regulations. Ferrite-core interface
cables are provided. This device will not be in compliance with
FCC regulations when a non-ferrite-core video cable is used.
SD2320W
Short DVI cable installed.
| 7 |
User's Guide
Advertisement
Table of Contents
