Connect The Cables - Planar Dome Q2 Reference Manual

QUICK LINKS
Contents
Index
Regulatory Information
Product Information
Warranty
GETTING STARTED
About the Q2 Display
Check Package Contents
Identify Components
Position the Display
Desk Stand Features
INSTALLING THE DISPLAY
Check System Requirements
Determine Chipset Installed
Install EX2 Controller
Connect Cables
Install Display Driver
Adjust Display Properties
OPERATING THE DISPLAY
Front-Panel Controls
Screen Adjustments
Dome CXtra Software
APPENDIXES
Troubleshooting
Specifications
Video Modes
USB Connections
Power Management System
Driver Removal
Gallery

Connect the Cables

Use only the cables and power cord supplied with the Q2 display.
1 Press the
PUSH button on the desk stand and remove the stand cover.
2 Plug one end of the video signal cable to the DVI port on the display.
Tighten the thumbscrews to secure the connection.
3 Plug the power cord into the power connector on the interface plate.
4 Plug the other end of the DVI cable into the video port on the installed
EX2 controller. Use DVI port #1
5 Plug the other end of the power cord into a grounded outlet.
6 Reattach the stand cover.
7 Power on your display first, then the computer.
Display ports for power and video
Dome Q2 Display
if you are installing only one display.
DVI port #1 for single display setup
Installation tips
Easy access to ports
For displays mounted on a desk
stand, rotate the screen from
landscape to portrait for easy access
to the ports. If you need to place
your display face down, lower it
carefully on a protective cloth to
protect the screen.
Threading cables
Thread the cables and power cord
through the back of the stand. Make
sure the cables run through the
notches. To reattach the stand cover
correctly, align the hooks with the
slots on the stand. Press the cover
into place. A click sound signals
a secure connection.
Restarting
Turn on your display before you turn
on your computer. Failing to do so
could damage the display.
13