Installing The Riser Kit - Electrolux FPRH17D7KF All Refrigerator Professional Series Servicing

Installing The Riser Kit On Early Models
(See Figure 2-19 to identify)
1. First, place a protective covering on the floor to
prevent damaging either the refrigerator unit, freezer
unit or the floor.
2. Lay the unit on its side, making sure the side with
the handle is laying closest to the floor to prevent
door from falling open.
3. Remove the two plastic leg levelers on the bottom
front side of the units.
4. Remove riser from its box. Locate plastic bag
containing the mounting hardware needed to install
the riser kit to the unit. The bag should contain four
mounting bolts and four washers for each riser.
5. Position the riser on the bottom of the unit, making
sure the slanted end is toward the back of the unit.
6. Place a washer on the bolt and feed the bolt
through the hole in the top of the riser kit and into
the threaded hole in the foot of the unit. DO NOT
TIGHTEN AT THIS TIME.
7. Repeat the above procedure for the three remaining
attachment points. (See Figure 2-19).
8. Once all four bolts are secured to the four feet of the
unit, tighten the bolts using a 1/2" socket or open
end wrench.
9. After installation, carefully upright the unit with the
help of an assistant.
Figure 2-19.
Section 2 Installation Information
Installing The Riser Kit On Late Models
(See Figure 2-20 to identify)
1. First, place a protective covering on the floor to
prevent damaging either the refrigerator unit, freezer
unit or the floor.
2. Lay the unit on its side, making sure the side with
the handle is laying closest to the floor to prevent
door from falling open.
3. Remove the two front leg leveler brackets, (2)
compressor support screws and rear leg levelers, if
applicable, as shown in Figure 2-20.
4. Remove plastic spacers and Hex Bolt 5/16-18UNC x
1.5" from the box and assemble the two together as
shown in Figure 2-21.
5. Using three HWD #12-24 X .70 screws, fasten the
right front Riser Kit Spacer & Hex Bolt Assembly as
shown in Figure 2-22.
6. Using three HWD #12-24 X .70 screws, fasten the
left front Riser Kit Spacer & Hex Bolt Assembly as
shown in Figure 2-22.
7. Using two HWD ¼ -20 x .87 screws, fasten the right
rear Riser Kit Spacer & Hex Bolt Assembly as shown
in Figure 2-22.
8. Using two HWD ¼ -20 x .87 screws, fasten the left
rear Riser Kit Spacer & Hex Bolt Assembly as shown
in Figure 2-22.
9. Now that all the spacers are assembled on the unit,
you may position the riser on the bottom of the unit,
making sure the slanted end is toward the back of
the unit. See Figure 2-23.
10. Once in position, feed the riser through the four
bolts. Properly mounted riser should hang in place.
11. Place a washer on the bolt and thread into the
provided Nut (6/16" UNC). DO NOT TIGHTEN AT
THIS TIME.
12. Once all four nuts are secured to the four bolts,
tighten using a socket or an open wrench.
13. After installation, carefully upright the unit with the
help of an assistant.
2-11