Cut-Out Dimensions - Electrolux FPRH17D7KF All Refrigerator Professional Series Servicing

Cut-Out Dimensions

1. Minimum opening of 66" High x 33" Wide x 25-1/4"
Deep opening required for single-unit "Built-In Look"
installation. 66" Wide required for double-unit
installation. (66" High to be measured from finished
floor to underside of soffit or overhead cabinet.)
2. Minimum 25-1/4" depth requires recessed electrical
outlet and copper water line.
3. Remove all wall / floor molding prior to built-in
installation.
4. When installing a unit adjacent to wall, cabinet or
other appliance that extends beyond front edge
of unit, 20" minimum clearance is recommended
to allow for optimum 140° door swing, providing
complete crisper access and removal. (Absolute 4"
minimum clearance will ONLY allow for 90° door
swing which will provide limited crisper access with
restricted removal.)
5. Water line for ice maker can enter opening through
floor or rear wall. Copper tubing recommended
between cold water line and water connection
location. Water line tubing recommended is 48"
minimum length by 1/4" diameter. Installation of
easily accessible shutoff valve in water line required.
6. To allow for ease of moving out side-by-side units
after installation, 84" minimum length of coiled
copper tubing recommended.
7. If optional Single or Double Trim Kit is to be used,
different cutout dimensions are required.
Optional Accessories
• Single Trim Kit – (PN# ALLFRZKIT).
• Double Trim Kit – (PN# DUOTRIMKIT).
• Ice Maker Kit – (PN# IM501).
Section 2 Installation Information
Figure 2-4. Freezer Unit Cut-out
Figure 2-5. Refrigerator Unit Cut-out
Figure 2-6. Trim Kits
2-5