Konftel 300 Application Notes page 8

3.2. Configuration of the Konftel units
The Konftel 300, as shown in Figure 2, can be configured via its keypad.
Use the "Line Mode" key to select "ANALOGUE" mode.
Testing with Avaya Communication Manager was done with a flash value of 60ms. The Konftel
300 flash duration can be configured via its keypad via the following sequence:
Press the "Menu" key
Push the "down" key to select "SETTINGS"
Push the "OK" key
Push the "down" key repeatedly to select "FLASH/R"
Push the "OK" key
Push the "up" and "down" keys as required to select the desired flash time value (60ms –
600ms)
Push the "OK" key to select the desired flash time
Push the "MENU" key to exit the menu
4. Verification Steps
Use the Konftel 300 to make a call to another extension. Verify that both parties can hear
each other well.
Verify that the Konftel 300 can initiate transfer and conference operations using its
"flash" key.
Verify that the keypad keys on the Konftel 300 can be used to navigate the menu of a
voice mail system or other service.
Verify that Konftel 300 can redial numbers using the "Last Number Dialed" access
code".
Verify that Konftel 300 can activate/deactivate voicemail coverage via the "Send All
Calls Activation/Deactivation" access codes.
5. Support
Support for Konftel products is available at
Web-based support:
Email:
International help desk: +46 90706489
North American help:
6. Conclusion
The Konftel 300 conference unit can be attached to the analog port of an Avaya Media Gateway
to enable all those present in a room to participate in a telephone conversation. The configuration
described in these Application Notes has been successfully compliance tested.
MRR; Reviewed:
SPOC 5/1/2008
http://www.konftel.com/
info@konftel.com
+1 866-606-4728
Solution & Interoperability Test Lab Application Notes
©2008 Avaya Inc. All Rights Reserved.
8 of 10
konftel300-CM