Front Tow Eye Installation; Rear Tow Eye Installation - Jeep Compass 2015 Operating Information Manual

CAUTION!
• The tow eye must be used exclusively for
roadside assistance operations. Only use
the tow eye with an appropriate device in
accordance with the highway code (a rigid
bar or rope) to flat tow the vehicle for a
short distance to the nearest service loca-
tion.
• Tow eyes MUST NOT be used to tow
vehicles off the road or where there are
obstacles.
• In compliance with the above conditions,
towing with a tow eye must take place with
two vehicles (one towing, the other towed)
aligned as much as possible along the
same center line. Damage to your vehicle
may occur if these guidelines are not fol-
lowed.

Front Tow Eye Installation

The front tow eye receptacle is located on the
lower right side of the front fascia.
To install the tow eye, remove the rubber plug
and thread the tow eye into the receptacle.
Insert the flat end of the jack handle through the
eye and tighten, refer to "Jacking and Tire
Changing in Section 6 for information". The tow
hook must be fully seated to the attaching
bracket through the lower front fascia as shown.
If the tow hook is not fully seated to the attach-
ing bracket, the vehicle should not be towed.
Front Tow Eye Installed

Rear Tow Eye Installation

The rear tow eye receptacle is located behind a
door, located on the left rear bumper fascia.
To install the tow eye, open the door using the
vehicle key or a small screwdriver, and thread
the tow eye into the receptacle.
Insert the flat end of the jack handle through the
eye and tighten, refer to "Jacking and Tire
Changing in Section 6 for information". The tow
hook must be fully seated to the attaching
bracket through the left rear bumper fascia as
shown. If the tow hook is not fully seated to the
attaching bracket, the vehicle should not be
towed.
Rear Tow Eye Installed
231