Front I/O Assembly - HP EliteDesk 700 G1 Maintenance And Service Manual

Front I/O assembly

1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Remove the front bezel
4.
Rotate the drive cage to its upright position.
5.
Disconnect the cables from the system board as follows:
Yellow connector labeled FRONT_USB
●
Black connector labeled MEDIA 3.0
●
Blue connector labeled FRONT AUD
●
58 Chapter 5 Removal and replacement procedures: Small Form Factor
(Preparation for disassembly on page
(Access panel on page
(Front bezel on page 24).
23).
22).