Applying The Arm Cuff - Lumiscope 1131 Manual

Applying the arm cuff

1. Plug in the cuff connecting tube into the unit.
2. Unwrap the arm cuff, leaving the "Index" end of the cuff through the D-ring of the cuff.
3. Put your left arm through the cuff loop. The "OK" range indication should be positioned closer
to yourself with the rubber tube pointing in the direction of your arm. Position the artery mark
( ) over the main arteries (on the inside of your arm) in the upper arm.
4. Turn your left palm upward
and place the edge of the arm
cuff at approximately
cm above the inner side of the elbow joint.
Tighten the cuff by pulling the "Index" end
of the cuff.
5. If the Index line falls within the OK range,
indicated at the edge of the cuff, this cuff
suitable for your use. If the Index line falls out
the OK range, you may need a special cuff
measurement. Please visit www.lumiscope.net
contact our
800-672-8293 for more information regarding
2
service department
to
at
y
y
is
of
for
or
1-
7
3