Turn And Lane-Change Signals; Headlamp High/Low-Beam Changer - Chevrolet 2007 Kodiak Owner's Manual

Turn and Lane-Change Signals

The turn signal has two upward (for right) and
two downward (for left) positions. These positions
allow you to signal a turn or a lane change.
To signal a turn, move the lever all the way up or
down. When the turn is finished, the lever will
return automatically.
To signal a lane change, just raise or lower the
lever until the arrow starts to flash. Hold it
there until you complete your lane change. The
lever will return by itself when you release it.
As you signal a turn or a lane change, if the arrows
don't flash but just stay on, check the turn signal
flasher and circuit breaker. See Fuses and
Circuit Breakers on page 341.
144
An arrow on the
instrument panel cluster
will flash in the
direction of the turn or
lane change.
If a bulb is burned out, replace it to help avoid an
accident. If the arrows don't go on at all when
you signal a turn, check the circuit breaker and for
burned-out bulbs.

Headlamp High/Low-Beam Changer

To change the headlamps from low to high
beam or high to low beam, pull the multifunction
lever all the way toward you, then release it.
When the high beams
are on, this light on the
instrument panel
cluster will also be on.