Front Wheel Bearings With; Oil-Filled Hubs - Chevrolet 2007 Kodiak Owner's Manual

To change an empty ether cylinder, follow
these steps.
1. Loosen the screw head on the
cylinder-to-bracket clamp.
2. Spread the clamp apart.
3. Clean any dirt from the neck of the cylinder
and the top of the valve before you take out
the cylinder.
4. Check the inside of the valve for any foreign
matter. Clean the valve as necessary.
5. Cover the valve to protect it from dirt and take
out the cylinder.
6. Install a new gasket whenever you take out
the cylinder. Use only one gasket and spread
a light film of clean oil on it before installation.
7. Put in the new cylinder. Turn it clockwise until
it just starts to contact the gasket.
8. Tighten the cylinder another half turn
(180 degrees). Don't over-tighten.
9. Retighten the cylinder clamp.

Front Wheel Bearings with

Oil-Filled Hubs

Notice: If you drive your vehicle through deep
water that is higher than the front or rear
axle, water may enter the axle housing and
cause the axle lubricant to break down.
This could damage the gears inside. Avoid
driving your vehicle through deep water.
You should avoid driving your vehicle through
deep puddles or standing water. If you must drive
through water that is higher than the front or
rear axle, see your dealer immediately afterward
to have the condition of the axle lubricant checked.
319