Motorola APX 7000 Basic Service Manual page 241

Disassembly/Reassembly Procedures: Serviceable Components of the Main Sub-Assemblies
8.8.4 Servicing VOCON Board Assembly (G)
8.8.4.1 Back up Battery
1. Complete steps from
Disassembly" on page
2. Remove the battery with the Black Stick.
NOTE: Make sure the positive side is facing upwards.
3. Press the new battery into the battery carrier until it is secured and fully snapped into place.
NOTE: There are no other serviceable components on the VOCON Board Assembly.
8.8.5 Servicing of RF Board Assembly
Complete steps
RF Board Assembly (F)
8.8.5.1 Battery Seal
1. Slide the Battery Connector Seal (35) from the battery contact header with the Black Stick.
2. Use the Black Stick and push the new Battery Connector Seal until it is properly seated onto
the RF Board surface.
Battery (31)
VOCON Board
Figure 8-30. VOCON Board Assembly
Section 8.7.1.
2:8-11.
8.7.1 through 8.7.6 of
Figure 8-31. RF Board Assembly
through Section 8.7.7.
Section "8.7 Radio Disassembly" on page
Battery Connector Seal (35)
of Section "8.7 Radio
2:8-11.
Inner Thermal Pad (34)
Outer Thermal Pad (33)
Sec 2: 8-21