Installing A Standard-Form-Factor Expansion Card - IBM BladeCenter HS20 Problem Determination And Service Manual

Installing a standard-form-factor expansion card

To install a replacement standard-form-factor expansion card, complete the
following steps.
1. If the expansion card tray was removed, secure the tray to the system board
2. Touch the static-protective package that contains the expansion card to any
3. Orient the expansion card and slide the narrow end of the card into the raised
4. Install the blade server cover (see "Installing the blade server cover" on page
5. Install the blade server into the BladeCenter unit (see "Installing the blade
Expansion
card
Expansion
card tray
Hard disk
drive tray
with the screws from the option kit or from the removed drive tray. If a SAS hard
disk or SAS hard disk drive tray is installed in SAS hard disk drive bay 1,
remove the SAS hard disk drive and drive tray (see "Removing a SAS hard disk
drive" on page 62).
unpainted metal surface on the BladeCenter unit or any unpainted metal surface
on any other grounded rack component; then, remove the expansion card from
the package.
hook on the tray; then, gently pivot the wide end of the card into the expansion
card connectors.
60).
server in a BladeCenter unit" on page 58).
Chapter 4. Removing and replacing blade server components
69