IBM BladeCenter HS20 Problem Determination And Service Manual page 87

Statement 2:
CAUTION:
When replacing the lithium battery, use only IBM Part Number 33F8354 or an
equivalent type battery recommended by the manufacturer. If your system has
a module containing a lithium battery, replace it only with the same module
type made by the same manufacturer. The battery contains lithium and can
explode if not properly used, handled, or disposed of.
Do not:
v Throw or immerse into water
v Heat to more than 100°C (212°F)
v Repair or disassemble
Dispose of the battery as required by local ordinances or regulations.
To install the battery, complete the following steps.
1. Follow any special handling and installation instructions that come with the
battery.
2. Insert the battery:
a. Tilt the battery so that you can insert it into the socket on the side opposite
the battery clip.
b. Press the battery down into the socket until it clicks into place. Make sure
that the battery clip holds the battery securely.
3. Install the blade server cover (see "Installing the blade server cover" on page
60).
4. Install the blade server into the BladeCenter unit (see "Installing the blade
server in a BladeCenter unit" on page 58).
5. Turn on the blade server and run the Configuration/Setup Utility program. Set
configuration parameters as needed (see "Using the Configuration/Setup Utility
program" on page 79 for information).
Chapter 4. Removing and replacing blade server components
71