List Of Error Display / Indications; Operator Call Errors - Canon PIXMA iP6220D Service Manual

2. LIST OF ERROR DISPLAY / INDICATIONS

Errors and warnings are displayed by the following ways:
1) Operator call errors are indicated by the Alarm LED lit. (In the service mode, the Alarm LED blinks to indicate
errors.)
Service call errors are indicated by the number of cycles the Alarm and Power LEDs blink.
2) Errors and warnings are displayed on the LCD on the operation panel.
3) Warnings are displayed on the MP driver Status Monitor.
2-1. Operator Call Errors (by Alarm LED Lit in Orange)
LCD Message
There is no paper.
Load paper and press
[OK].
The paper is jammed.
Clear the paper and
press [OK].
Ink has run out.
Replace the ink
cartridge and close
the cover.
U041
The following ink
cartridge cannot be
recognized.
U051 / U059
The following ink
cartridge cannot be
recognized.
U052
The following ink
cartridge cannot be
recognized.
U140
Some ink cartridge
are not installed in
place.
U075
Some ink cartridge
are not installed in
place.
U076
The following ink
cartridge cannot be
recognized.
U053
The waste ink
Alarm LED
blinking in
orange (in the
Error [Error code]
service mode
only)
No paper. (ASF)
2 times
[1000]
Paper jam. [1300]
3 times
- No ink. [1600]
Ink cartridge not
5 times
installed. [1401]
Ink cartridge not for
this model installed.
[1485]
Ink cartridge not
15 times
installed. [1682]
Ink cartridge not for
-
this model installed.
[1684]
Multiple ink cartridges
7 times
of the same color
installed. [1687]
Ink cartridge in a
7 times
wrong position. [1686]
Improper installation
4 times
of an ink cartridge.
[1687]
- Warning: The waste
Solution
Set the paper in the ASF,
and press the OK button.
Remove the jammed
paper, and press the OK
button.
Replace the empty ink
cartridge(s), or press the
OK button.
Confirm that the ink
cartridges are for this
model, install them
properly, then close the
front cover.
Re-install the applicable
ink cartridge(s) properly,
and close the front cover.
Or, with the ink
cartridges installed, turn
the machine off and on
again.
Confirm that the ink
cartridges are for this
model, install them
properly, then close the
front cover.
Replace the wrong ink
cartridge with the correct
one.
Install the ink cartridge
in the correct position.
Re-install the applicable
ink cartridge(s) properly,
and close the front cover.
Pressing the OK button
1-4
Remarks
Pressing the OK button will
exit the error without ink
cartridge replacement,
however, ink may run out
during printing.
The service call error,