List Of Error Display / Indications; Operator Call Errors - Canon PIXMA MP170 Service Manual

2. LIST OF ERROR DISPLAY / INDICATIONS

Errors and warnings are displayed by the following ways:
1) Operator call errors are indicated by the Alarm LED lit. (In the service mode, the Alarm LED blinks to indicate
errors.)
Service call errors are indicated by the number of cycles the Alarm and Power LEDs blink.
2) Errors and warnings are displayed on the LCD on the operation panel.
3) Warnings are displayed on the MP driver Status Monitor.
2-1. Operator Call Errors (by Alarm LED Lit in Orange)
MP450 LCD
MP170 LCD
There is no
LOAD PAPER
paper.
The paper is
PAPER JAMMED
jammed.
Ink has run out.
CHECK INK
Replace the ink
U041
cartridge and
close the cover.
U041
The following CHECK INK
ink cartridge
U051 / U059
cannot be
recognized.
U051 / U059
The following
CHECK INK
ink cartridge
U052
cannot be
recognized.
U052
The following
CHECK INK
ink cartridge
U053
cannot be
recognized.
U053
The waste ink WASTE INK
absorber is NEAR FULL
almost full.
Alarm LED
blinking in
orange (in
Error [Error code]
the service
mode only)
No paper. (ASF)
2 times
[1000]
Paper jam. [1300] Remove the jammed
3 times
- No ink. [1600]
Ink cartridge not
5 times
installed. [1401]
Ink cartridge not
for this model
installed. [1485]
Ink cartridge not
15 times
installed. [1682]
Improper
4 times
installation of an
ink cartridge.
[1687]
- Warning: The
waste ink absorber
becomes almost
full.
[1700 for the main
waste ink
absorber, 1710 for
the platen waste
ink absorber]
1-4
Solution
Set the paper in the
ASF, and press the OK
button.
paper, and press the OK
button.
Replace the empty ink
cartridge(s), or press
the OK button.
Confirm that the ink
cartridges are for this
model, install them
properly, then close the
scanning unit.
Re-install the
applicable ink cartridge
(s) properly, and close
the scanning unit.
Or, with the ink
cartridges installed,
turn the machine off
and on again.
Re-install the
applicable ink cartridge
(s) properly, and close
the scanning unit.
Pressing the OK button
will clear the error, and
enable printing.
*1
At repair :
For main waste ink
absorber replacement,
replace
- the bottom case unit
(MP170: QM2-2800
MP450: QM2-2814),
or
- the ink absorber kit
(MP170: QY5-0149
Remarks
Pressing the OK
button will exit the
error without ink
cartridge replacement,
however, ink may run
out during printing.
The service call error,
indicating the waste
ink absorber is full, is
likely to occur soon.