Error Display - Canon ip1500-srm Simplified Service Manual

3. ERROR DISPLAY

Errors are displayed by the LEDs, and ink low warnings are displayed by the Status Monitor.
3-1. Operator Call Error (LED Blinking in Orange)
LED
blinking
2 times Paper out
3 times Paper jam
4 times Ink tank not installed
5 times Print head not installed or failure has
occurred in the print head.
(Non-supported print head (see page 4) is
installed or print head EEPROM data is
abnormal.)
8 times Waste ink absorber full or platen waste ink
absorber full warning (approx. 95% of the
maximum capacity)
3-2. Service Call Error (LED Blinking in Orange and Green Alternately)
LED
blinking
2 times Carriage error
3 times LF error
7 times Waste ink absorber full or platen waste ink
absorber full
8 times Print head temperature rise error
9 times EEPROM error
10 times No print head detected excepting print head
replacement (during printing)
Error
Error
( 5 / 21 )
Corrective action
Set paper, and press the Resume/Cancel button
to feed the paper.
Remove the jammed paper, and press the
Resume/Cancel button.
Re-install the ink tanks, and close the access
cover.
Install the print head, and close the access cover.
Or, confirm the print head is "QY6-0054-000" and
perform re-installation. If not recovered, with the
print head installed, power the printer off and on.
Pressing the Resume/Cancel button will exit the
error, and enable printing.
Corrective Action
Replace the printer as it has failed.
Replace the printer as it has failed.
Replace the printer as it has failed.
Replace the printer as it has failed.
Replace the printer as it has failed.
Replace the printer as it has failed.