Use Of The Control Panel; Frost Protection - Baxi EcoBlue System 12 Installation And Service Manual

8 Operation
Boiler Information
View
/P
THESE BUTTONS
INACTIVE !
except when an
outdoor sensor relay
kit is connected
50 EcoBlue System
Standby - Reset - Esc
R
/R
+ +
Central Heating
Temperature Adjustment
On/Off Selector
Button
Display Screen
R
R
8.4

Use of the Control Panel

Key to Controls
R
Standby - Reset - Esc Button
EcoBlue
Boiler Information View Button
Increase CH Temperature Button
Decrease CH Temperature Button
Inactive Button
Inactive Button
On/Off Selector Button
When
to timed Heating or Hot Water demand.
N.B. If only
Mode
1. Press
Boiler On mode
To increase or decrease the boiler temperature
1. Press
2. Press
An overheat thermostat (NTC) is positioned in the heat
exchanger which shuts down the appliance if the boiler
temperature exceeds 100°C. Press
re-establish normal operating conditions.
8.5

Frost Protection

1. The boiler incorporates an integral frost protection feature
that will operate in both Central Heating and Domestic Hot
Water modes, and also when in standby (
section 4.2.3 Boiler Frost Protection Mode.
Except when an
outdoor sensor relay
kit is connected
is displayed (Boiler On) the boiler will respond
is displayed the boiler will not operate !
button until the required mode appears:-
to increase the Central Heating temperature.
to decrease the Central Heating temperature.
R
button to
displayed) see
7219708 - 01 (04/15)