Bowflex TC1000 Service Manual page 6

Table 2 – Mechanical Troubleshooting
Problem
2.1 Pedals lock up while
operating.
2.2 No resistance on pedals
when in a program.
2.3 Very little resistance at
any level.
5
Possible Reasons
Power supply board
(Item 23) is faulty.
Brake (Item 30) is faulty.
No speed signal
Wires going to brake
(Item 30) are discon-
nected.
Power supply board
(Item 23) is faulty.
Speed sensor (Item 37)
improperly adjusted.
Bad speed sensor
connection with power
supply board (Item 23).
Solutions
Unplug power cord. If pedals now
move freely, replace power supply
board.
If pedals do not move with power
cord unplugged, replace brake. See
Procedure 4.
Check and adjust the speed sensor
(Item 37) as needed. See
Procedure 3.
Check that brake wires are properly
connected.
Check and replace power supply
board as needed. See Procedure 2.
Check and adjust the speed sensor
as needed. See Procedure 3.
Check voltage at power supply
board. See Procedure 2.