Pioneer MEH-P5000R II Service Manual page 95

RFG
" " key in the main unit
SAT
" " key in the main unit
SBT
" " key in the main unit
HAO
" " key in the main unit
HBO
" " key in the main unit
HEO
" " key in the main unit
HFO
" " key in the main unit
TCO
" " key in the main unit
LAO
" " key in the main unit
LBO
" " key in the main unit
LEO
" " key in the main unit
LFO
* Pressing "SCR" key in the main unit in each status switches to "TEST STOP" .
* Pressing "F" key in the main unit in each status where a setting value is displayed changes the
digit of the setting value that will be changed.
• When the setting value has two digits.
The first digit
(Initial value)
--
***
• When the setting value has three digits.
The first digit
"F" key in the
(Initial value)
main unit
___
***
* Pressing VOL UP/DOWN key in each status where a setting value is displayed changes the
value in the digit you selected in the range from 0
the setting value of RF side gain changes in the range from 0
" ' " key in the main unit
___
'
" " key in the main unit
___
" ' " key in the main unit
" ' " key in the main unit
" ' " key in the main unit
'
" " key in the main unit
'
" " key in the main unit
'
" " key in the main unit
" ' " key in the main unit
" ' " key in the main unit
" ' " key in the main unit
"F" key in the
The second digit
main unit
***
"F" key in the
main unit
The second digit
___
***
H
MEH-P5000R—,P5000,P5050
: Fine tuning of RF side focus gain
: Setting value of gain
: A-ATT (Focus) initial setting
___ : ATT setting value
: B-ATT (Focus) initial setting
___ : ATT setting value
: Measurement of S gain "High" A signal offset (AINO)
: Measured value
: Measurement of S gain "High" B signal offset (BINO)
: Measured value
: Measurement of S gain "High" E signal offset (EINO)
: Measured value
: Measurement of S gain "High" F signal offset (FINO)
: Measured value
: Measurement of TCRS signal offset (TCRSO)
: Measured value
: Measurement of S gain "Low" A signal offset (AINO)
: Measured value
: Measurement of S gain "Low" B signal offset (BINO)
: Measured value
: Measurement of S gain "Low" E signal offset (EINO)
: Measured value
: Measurement of S gain "Low" F signal offset (FINO)
: Measured value
--
"F" key in the
The third digit
main unit
***
"F" key in the main unit
through F . However,
H
through 6 .
H H
___
95