JVC MX-KA3 Service Manual page 12

MX-KA3
Removing the CD pickup (See Fig.16)
Prior to performing the following procedures, remove
the top cover.
Also remove the CD changer unit.
Also remove the CD changer mechanism.
1. Widen the section f.
2. While keeping the section f wide open, push the
section g in the direction of the arrow to remove the
shaft, and then remove the CD pickup.
Replacing the loading motor and rotor
belt of the CD changer
Prior to performing the following procedures, remove
the top cover.
Also open the CD changer tray.
1. Remove the two screws L retaining the CD
changer tray loading motor.
2. Remove the two screws M retaining the gear
plate and take it out, after remove the rotor belt
from the pulley.
Replacing the CD turn table and remov-
ing the motor
Prior to performing the following procedures, remove
the top cover.
Also remove the CD changer unit.
1. Remove the one screws N retaining the CD (Turn
table).
2. Remove the two screws O retaining the stopper
brackets on both sides of the CD changer unit.
3. Remove the stopper brackets from both sides of the
CD changer unit.
4. Pull out the CD tray from the CD changer unit, all
the way and lift the tray (u/~ ward) to remove.
5. Remove the gear and after push out the tray motor
locker and pull out the tray motor from the CD tray.
1-12
f
(See Fig .17)
(See Fig. 19 )
CD pickup
Shaft
Fig.16
L
Fig.17
Turn table motor
, and then remove the CD tray
Fig.18
g
M
Motor locker
Obligue gear