Table of Contents
Advertisement
The software "RF-MANAGER"
8.1
Prerequisites for working with the software "RF-MANAGER"
8.1.1
Necessary components
WLAN module
Communication with the runtime system of RF-MANAGER is performed over a radio link.
The SIMATIC RF WLAN module is required for this purpose.
Barcode scanner
When reading of bar codes is configured in the engineering system of RF-MANAGER, you
will need the accessory SIMATIC RF barcode scanner for the SIMATIC RF680M device.
Both components can be ordered and installed separately as accessories. [See Ordering
data (Page 95) ].
8.1.2
Starting the software "RF-MANAGER"
To start the RF-MANAGER application, double-click the "RF-MANAGER" icon on the
desktop.
A connection to RF-MANAGER will only be established when the "RF-MANAGER" software
has been started and the WLAN connection is active.
After it has been correctly installed, the SIMATIC RF680M Mobile Reader automatically
receives its configuration from RF-MANAGER.
8.1.3
Preconditions for parameterization of the WLAN connection
● The mobile reader must be ready for operation (the battery is charged).
● The mobile reader must contain a WLAN card.
● A WLAN connection must exist between the reader and the network of the PC, e.g. via an
● Information regarding the WLAN settings must be available.
● The operating mode of the mobile reader must be set to "Supervisor".
SIMATIC RF680M Mobile Reader
Operating Instructions, 06/2011, J31069-D0241-U001-A2-7618
access point.
8
29
Advertisement
Table of Contents
