Table of Contents
Advertisement
Requirement
The reader is connected to the PC.
Procedure
Copy all the data from the directory "Flash Disk" to your PC. See also Chapter Data transfer
between the PC and mobile reader (Page 84)
NOTICE
Do not delete files with the extension ".PFL"
Files with the extension ".PFL" in the "Flash Disk" directory are used to restore the status
that existed at the time of the last back-up and must therefore not be modified or deleted. If
the files with the ending ".PFL" are damaged or lost, the original status of the device can
only be restored at the factory.
To restore a backup, replace all the data on the device with your backup copy and then run
a system reset.
5.3.2
Changing the password for the operating system
Assign a password to protect the system from unauthorized access.
Prerequisite
The operating mode must be set to "Supervisor". See Chapter Operating modes (Page 22)
Procedure for changing the password
To change the password of the operating system, select "Start > Security". Enter the
previous password. The password on delivery is "123456".
You can assign a new password using the button "Set Password".
5.3.3
Performing a back-up
Set the operating mode to "Supervisor". See Chapter Operating modes (Page 22)
Select "Start > Settings > Control Panel > Total Recall".
1. Select the "Create Profile" button.
2. Select "Auto Restore" and then confirm with the "-->" button.
3. Select "Default Backup" and confirm this with the "Create Profile" button.
4. Click "Finished" to return to the application.
SIMATIC RF680M Mobile Reader
Operating Instructions, 06/2011, J31069-D0241-U001-A2-7618
Reaction: The backup is started.
5.3 Recommendations for first commissioning
Commissioning
21
Advertisement
Table of Contents
