Initial Installation; Installing The Tv Set; Preparing The Remote Control Unit; Connecting The Tv Set - Loewe R 37 Full-HD+ 100, R 37 HD+ 100 Operating Instructions Manual

Initial installation

Installing the TV set

First prepare the chosen installation solution for your TV set. See the
installation instructions of the table stand supplied. See accessories (page
68) for other installation possibilities.

Preparing the remote control unit

Inserting or replacing batteries
Press the embossed arrow and push down the
battery compartment cover.
Insert two alkaline manganese LR 03 (AAA) batteries;
ensure that the + and – poles are correctly positioned!
Slide the cover up from below.
Adjusting the remote control for operating the TV set
Press the TV button.
See page 62 to learn about operating other Loewe
devices.
- 10

Connecting the TV set

Connecting to the mains
Remove the cover for the connections.
Connect the TV set to a 220-240V outlet:
First plug the small plug of the mains cable into the
mains connection on the rear of the TV, then plug the
large plug into a mains power outlet.
Connecting the antenna
Analogue / DVB-C / DVB-T antenna:
Plug the antenna plug of antenna system, cable system,
or room antenna into the ANT2 socket.
The connecting cable between ANT-TV – ANT OUT is
plugged at the factory.
Satellite antenna:
Connect an antenna plug, e.g. from the antenna change-
over switch or from the twin-LNC of the satellite system
to the sockets ANT-SAT resp. ANT-SAT2.
When connecting only one SAT antenna cable, connect
it to ANT-SAT.
ANT2
ANT
SAT2
TV
R
Connections on the back of the set see also page 5.
Replace the cover over the connections.
Receiving coded stations
When using a CA module and a Smart Card to receive
coded stations, please observe the handling of the CA
module (see page 35).
ANT
220-240V~
SAT
50/60Hz