Initial Installation; Batteries - Remote Control; Connection; Switching On - Loewe Cantus 3870 Z Operating Instructions Manual

Initial installation

Batteries – Remote
control
To insert or change the batteries, press the
point marked by an embossed arrow. Push the
cover of the battery compartment down and
remove it. Insert the batteries of the alkaline
manganese type LR 03 (AAA) with the correct
polarity (+/–).
Then push the cover back on.
Note on disposal of batteries:
The original batteries do not
contain any pollutants such as
cadmium, lead and mercury.
Used batteries do not belong in
the domestic waste. They must
be taken to the appropriate
collection points according to the
national laws. Ask your dealer.

Connection

Mains
Connect the TV set to a 230V/50–60 Hertz
outlet.
Antennae
Connect your antenna or cable system to the
VHF/UHF antenna socket.
If your TV is equipped with a picture-in-picture
tuner (PIP), plug the antenna plug protruding
from above the PIP antenna socket into the
+
antenna socket for the VHF/UHF tuner. Plug the
antenna plug of your antenna or cable system
into the socket of the PIP tuner.
If your TV set is equipped with one or two
satellite tuners, connect the SAT antennae to
+
the SAT sockets (see figure on page 5).

Switching on

You will find the On/Off button of the TV,
except in Cantus, behind the control panel
cover. Open the control panel flap.
SAT
SERVICE
SAT A/D
AV1 AV2/RGB
R
AUDIO OUT
VHF/UHF L
SUBWOOFER
STAND
Press the On/Off button so that
it snaps in.
Initial installation
Automatic programming of the TV set is started
the first time you switch it on. Follow the
menus.
First you have to select the menu language for
your set. Then you specify which antenna you
have connected to your TV and in what country
you are using it. Then you start the station
search. The TV searches for, stores and sorts all
the stations which your antenna system
receives. You then see a list of the stored
stations in which you can mark your favorites.
Then you log in your video recorders and
connect them as shown in the wiring diagram.
Select the settings with the
arrows on the ring ...
... confirm the settings with
OK
OK. You then move on to the
next menu ...
... press this button if you want
i
information about the settings.
You can repeat initial installation at any time,
e.g. after moving house. Call the index in the
main information (i button). Then select the
item "Repeat initial installation". Then start
"Initial installation" with OK.
9