Sony Walkman MZ-R91 Operating Instructions Manual page 74

MEM OVER :
You started recording with the recorder
receiving continuous vibration. Put the
recorder on the stable place and start
recording again.
NO COPY :
You tried to make a copy from a disc that
is protected by the Serial Copy
Management System. You cannot make
copies from a digitally connected source
which was itself recorded using the
digital connection. Use the analog
connection instead.
NO DISC :
You tried to play or record with no disc in
the recorder.
NO SIGNAL :
The recorder could not detect digital
input signals. Make sure that the source is
connected firmly. If the message appears
while recording, press p to end
recording.
P/B ONLY :
You tried to record or edit on a
premastered MD (P/B stands for
playback).
PROTECTED :
You tried to record or edit on an MD with
its tab in the record-protect position.
SORRY :
You tired to set DIGITAL MEGA BASS
while the "AUDIO OUT" parameter is set
to "LINE OUT." Use the jog lever to set
the "AUDIO OUT" parameter to
"HeadPhone."
You tried to erase a track mark while
playing the MD or at the beginning of the
first track.
You tried to erase a track mark to
combine tracks the recorder cannot
combine*.
You tried to press P or T MARK while
synchro-recording or the joint text
function is active.
* If you have recorded or erased many times
on the same MD, the data of a single track
may be scattered throughout the MD. When
the data is scattered in groups of less than 12
seconds long, the recorder will not be able to
combine the tracks.
TEMP OVER :
Heat has built up in the recorder. Wait
until the recorder cools down.
TR FULL:
You tried to record more than 254 tracks.
74
TrPROTECT :
You tried to record over or edit a track
which has been protected from being
recorded over*.
* Track-protected MiniDiscs — Some MD
recorders will let you protect individual
tracks from being recorded over. This
recorder, however, does not offer this
feature.
EDITING
You pressed a key on the recorder while
editing on the remote control, or vice
versa.
LINE OUT
You pressed VOL +/– while the "AUDIO
OUT" parameter is set to "LINE OUT."
Use the jog lever to set the "AUDIO
OUT" parameter to "HeadPhone."
NO TEXT
You tried to use the CD text copying
function to copy a track or disc name
from a CD that has no text data.
EMPTY
You tried to erase data in the phrase bank
but no data have been recorded.
BANK FULL
The phrase bank is almost full and cannot
store the phrase you tried to enter.
Delete some phrases from the phrase
bank, and then reenter the new phrase.