Sony Walkman MZ-R91 Operating Instructions Manual page 71

Searching for a phrase by displaying the
stored phrase one by one
1 Do the procedure "Labeling
recordings" (page 68) until
" :Name" or "
the display. Then press the jog lever.
Press P repeatedly until the first
2
phrase stored in the phrase bank
appears in the display.
Flip the jog lever or press =/+
3
repeatedly.
Flipping the jog lever or pressing the
buttons causes the phrases stored in
the phrase bank to appear one by one
in sequential order. If you press P at
this time, the first phrase stored in the
phrase bank retrieved.
4 Press the jog lever while the phrase
you want is shown in the display.
The cursor flashes after the phrase you
just retrieved. You can then continue
with labeling operation.
Searching for a phrase by its first letter
1 When labeling a track or disc, use VOL
+/– to move the cursor to the letter
which the desired phrase begins with.
Press P to search.
2
The phrase for that letter appears in
the display. If there are two or more
phrases that start with that letter, press
P to see the next phrase.
3 Press the jog lever while the phrase
you want is shown in the display.
The cursor flashes after the phrase you
just retrieved. You can then continue
with labeling operation.
Erasing phrases
You can erase phrases from the phrase
bank while the recorder is stopped. You
can also erase phrases when the recorder is
empty.
Press the jog lever so that "EDIT"
1
appears, and then press the lever
again.
2 Flip the jog lever until "BankErase"
appears, and then press the lever.
:Name" flashes in
3 Flip the jog lever until the phrase you
want to erase appears, and then press
the lever.
"Erase!" appears and the phrase is
erased. If no phrase is stored in the
phrase bank, "EMPTY" appears in the
display.
To cancel the operation, press p or T
MARK
On the remote control
Storing phrases while labeling
1 Do the procedure "Labeling on the
remote control" in "Labeling
recordings" (page 69) to enter a phrase.
After entering the phrase, press P for 2
2
seconds or more.
"Entry!" appears in the display and the
cursor flashes after the phrase you just
stored. You can then continue with
labeling operation.
Storing phrases using the EDIT menu
1 Press DISPLAY for 2 seconds or more.
Press the control towards = or
2
towards (•+ repeatedly until
"Name Bank" flashes in the display,
and then press p.
3 Enter the phrase you want to store,
then press p for 2 seconds or more.
"Entry" appears in the display and the
phrase is stored.
Retrieving phrases stored in the phrase
bank
Searching for a phrase by displaying the
stored phrase one by one
1 Do the procedure "Labeling on the
remote control" in "Labeling
recordings" (page 69) until
" :Name" or "
in the display.
Then press p.
2 Press P repeatedly until the first
phrase stored in the phrase bank
appears in the display.
:Name" appears
continued
71