Before Use; Installation - Prem-I-Air Elite EH1460 Instructions For Use Manual

These instructions should be read carefully and left with the user of the
product for future reference.
Inspect the product including its cable and plug for any signs of damage.
If the product is damaged, DO NOT use it, and contact your supplier
immediately. The appliance contains a refrigerant gas, so must be kept
upright at all times. After unpacking wait 3 hours for the refrigerant gas to
stabilise before use.
Stand the appliance on a firm, flat, level surface, at least 500 mm from
the nearest wall.
Connect the exhaust hose as follows: expand a small section of the end,
and screw into the indoor adaptor; then slide the indoor adaptor into the
slot at the back of the unit. Expand a small section of the other end of the
hose, and screw into the fish-tail-shaped adaptor.
Slide the two-part window adaptor to the correct length to fit the window
(as shown opposite). Close the window as far as possible to keep the
window adaptor in place. Clip the fish-tail shaped adaptor into the
obround aperture in the window adaptor.
IMPORTANT
Installer and Users please note:

BEFORE USE

INSTALLATION

1.Control panel
2. Horizontal louvres
3. Vertical louvres
4. Handle
5. Air inlet grille
6. Castor
7. Exhaust pipe
8.Water injection port
9. Mains lead tidy
10. Air filter
11. Air outlet grille
12. Water tank connector
13. Water tank indicator
14. Mains lead and plug
Page 2