Before Use; Installation - Prem-I-Air EH1412 Manual

IMPORTANT
Installer and Users please note:
These instructions should be read carefully and left with the
user of the product for future reference.

BEFORE USE

Inspect the product including its cable and plug for any signs
of damage. If the product is damaged, DO NOT use it, and
contact your supplier immediately.

INSTALLATION

Transport and store in an upright position. Leave the
appliance in an upright position for at least 3 hours before
first use.
Select a location for the internal unit - it should be close to a
door or opening window to allow the exterior unit to be placed
outside, but not too close to a wall to avoid obstructing the air
flow. Allow 200mm (8") around the appliance on all sides, to
achieve optimum efficiency and lowest operating noise.
Pass the external unit through the open door or window, and
then close the door or window to the minimum gap that will
allow the flexible hose through.
If the appliance is to be used frequently in the same location,
then the bracket can be attached to the exterior wall, and the
external appliance can be hung on the bracket.
The internal and external units must remain connected by the
flexible hose at all times. The flexible hose may only be
disconnected by persons with the necessary qualifications
under the "F Gas Regulations".
Page 2