Honeywell LYNX Touch User Manual page 26

SECURING THE PREMISES
Disarming the System
Disarming the system during Entry Delay
Armed Stay - Disarm Now
Disarm Now
ARMED READY
Enter Code:
Cancel
When an Alarm Occurs
When an alarm has occurred, the touch screen displays the zone number(s) that caused the
alarm and the type of alarm (e.g., "Fire Alarm"). These messages remain displayed until
cleared by a user. To clear the display, note the zone number displayed and enter an Off
sequence. If the fault cannot be corrected, notify your alarm company.
Disarming the system and silencing alarms
Alarm
Alarm
Enter Code:
Cancel
Alarm
Alarm 2
Front Door
Disarm
4:43 PM August 11, 2011
1 2 3
4 5 6
7 8 9
Clear 0
5000-100-201-V0
1 2 3
4 5 6
7 8 9
Clear 0
5000-100-202-V0
Zones System
Message
More
5000-400-315-V0
– 26 –
Upon entering the premise when the system is
armed, the control will announce "disarm
system now".
1. Enter a valid Code. The system will beep
once and announce "Disarmed Ready to
Arm".
Note: If a valid user code is not entered before
the programmed entry delay occurs, the
system enter alarm mode.
1. Enter a valid Code. The system will beep
once and announce "Disarmed Ready to
Arm".
Note: If a valid user code is not entered before
the programmed entry delay occurs, the
system remains in alarm mode.
2. The zone that caused the alarm is
displayed. Enter an Off sequence to clear
the alarm. The system will beep once and
announce "Disarmed Ready to Arm".