System Menu - Sony DXC-990P Instructions For Use Manual

SYSTEM Menu

The SYSTEM menu is used to set the items
relating to the system of the camera and
selection of output signals.
<SYSTEM>
>BAUD RATE
D-SUB OUT
D-SUB VIDEO
D-SUB SYNC
RGB SYNC
12P CONNECTOR
Select
MENU
BAUD RATE
Switches the baud rate of the REMOTE
connector.
Sets to any of 19200, 9600, 4800, 2400
and 1200.
Set to 9600 when the RM-C950 remote
control unit is connected.
Note
When the CMA-D3CE
camera using the CCMC-3MZ
cable, "CMA-D3" will appear and you
cannot select the baud rate.
* CMA-D3CE/CCMC-3MZ are intended for general
purpose use. They are not intended for medical use.
D-SUB OUT
Selects the RGB (R/G/B) or component (Y/
CR/CB) signal output from the RGB/SYNC
connector (D-sub 9-pin).
D-SUB VIDEO
Selects the VBS or Y/C signal output from
the RGB/SYNC
pin).
24
SYSTEM Menu
[A]
9600
R/G/B
VBS
C.SYNC
G
IN
Back
*
is connected to the
*
connecting
connector (D-sub 9-
Note
When the CMA-D3CE
camera with the CCMC-3MZ
cable, the item does not function.
* CMA-D3CE/CCMC-3MZ are intended for general
purpose use. They are not intended for medical use.
D-SUB SYNC
Selects the sync signal output from the RGB/
SYNC connector (D-sub 9-pin).
C. SYNC
Outputs the composite sync signal.
WEN (WEN 1-3)
Outputs the WEN signal. When connecting
peripheral equipment, the signal is used as
trigger pulse output to the equipment.
Switching WEN 1 to 3 provides a different
pulse signal phase.
For the timing chart of the WEN pulse signal
for each setting, see page 43.
Note
When TRIGGER in the GENERAL menu is
set to OFF, D-SUB SYNC is always set to
WEN and you cannot select a different
phase.
POLARITY
Selects the polarity of the pulse signal.
: Negative
: Positive
Note
When the CMA-D3CE
camera with the CCMC-3MZ
cable, you cannot select C. SYNC.
* CMA-D3CE/CCMC-3MZ are intended for general
purpose use. They are not intended for medical use.
RGB SYNC
Adds a sync signal to the G signal or R, G
and B signals output from the RGB/SYNC
connector.
*
is connected to the
*
connecting
*
is connected to the
*
connecting