Roland VersaCamm VS-640 Setup Manual page 28

3. Assembling and Installing
x
In the same way as the left media, pass the right media holder onto the shafts and at-
tach the retaining screw.
Only light tightening is necessary for the retaining screw.
y
Attach the shaft clamps to secure the shafts in place.
Do not place the media holders too close to the edge so that they will not get caught in the shaft
clamps.
Hexagonal
wrench
Bolt
Shaft clamp
26
Retaining screws
Tighten loosely.
Hexagonal
wrench
Bolt
Shaft clamp