Setup > Time - Linksys SLM248G4S (G5) User Manual

Chapter 
The Network Settings screen allows you to edit the
following information.
Identification
System Name
Specifies the name of the Switch. Enter the
name into the text field provided. By default, the system
name is LS-SLM224G4 or LS-SLM248G4.
System Locaton This is used to enter a description of
where the Switch is physically located, such as rd Floor.
System Contact
Enter the name of the administrator
responsible for the system.
System Object ID
This is used for SNMP purposes and is
set to 1...1.4.1.9...224(248).2.
Base MAC Address Displays the Switch's physical address.
IP Configuration
Management VLAN
This drop-down menu allows you to
select the Management VLAN. The default value is 1.
WARNING:
If the system IP address (IP Address
field) is set to 192.18.1.24, then keep the
default values for the Management VLAN field
(default value: 1), and the Default Gateway
field (default value: 0.0.0.0). These fields must
remain set to the default values. Otherwise, you
may not be able to access the system.
IP Address Mode Specifies whether the Switch's IP
address is Statc or dynamically assigned using DHCP
(Dynamic Host Configuration Protocol). Selecting Statc
allows you to enter a static IP address, subnet mask and
default gateway using the text field provided. The default
setting is Static.
IP Address If you are using a static IP address, enter
the IP address here. The Switch's default IP address is
192.18.1.24.
Subnet Mask
If you are using a static IP address, enter
the subnet mask for the currently configured IP address.
The default subnet mask is 2.2.2.0.
Default Gateway
If you are using a static IP address,
enter the IP address of the default gateway. The default
value is 0.0.0.0.
DNS Server
If you are using a static IP address, enter the
IP address of the DNS server. A second DNS address can be
specified in the additional text field provided.
Click Save Settngs to save your changes. Click Cancel
Changes to cancel your changes.
24/48-Port 10/100 + 4-Port Ggabt Reslent Clusterng Smart Swtch wth 2 Combo SFPs
Configuration Using the Web-based Utility
Setup > Time
The Time screen allows you to configure the time settings
for the Switch.
Local Time
Here you set the system date and time for the Switch. All
settings noted as "two-digit" must contain a leading zero if
the value is less than 10 (for example, 01 instead of 1).
Hours
Enter the two-digit hour here.
Mnutes
Enter the two-digit minutes here.
Seconds
Enter the two-digit seconds here.
Month
Enter the two-digit month here.
Day
Enter the two-digit day here.
Year
Enter the last two digits of the year here (for example,
0 instead of 200).
Tme Zone Select your time zone from the drop-down
menu. Time zones are identified by the difference between
Greenwich Mean Time (GMT) and local time.
Daylight Saving
This is where you configure Daylight Saving Time.
Daylght Savng
To enable daylight saving time, check
the box, then select either USA or European to use US
or European daylight saving time, respectively. To use a
different type of daylight saving time, select Custom, then
customize the following settings:
Tme Set Offset Enter the time difference in minutes
•
for daylight saving time. The default is 0 minutes.
From
Enter the starting date for daylight saving time
•
using the format DD/MM/YY.
Setup > Time
1