Permanent Installation; Shock Mount; Specifications - Shure MX412S User Manual

4
Permanent Installation
Mount the microphone using one of the following methods.
1
Specifications
Cartridge Type
Electret Condenser
Frequency Response
50-17000
Hz
Polar Pattern
MX412/C, MX418/C
MX412/S, MX418/S
Output
Impedance
1800
Output Configuration
Active Balanced
Sensitivity
@
1 kHz. open circuit voltage
Cardioid
Supercardioid
1 Pa:94 dB SPL
MaxlmumSPL
1 kHz at 1% THD, 1 kO load
Cardioid
Supercardioid
Equivalent Output Noise
A-weighted
Cardioid
Supercardioid
Flange
1. Drill a 22 mm (7/8 in.) diameter hole in the
desired location.
2. Trace and drill three starter holes for the
supplied screws using the flange as a template.
3. Insert the preamplifier through the mounting
flange.
4. Slip the mounting flange retaining ring over the
bottom of the preamplifier and slide it up until it
is flush to the bottom of the flange. Then press
the ring firmly into place.
5. Secure the flange to the mounting surface with
three screws.
Cardioid
Supercardioid
Signal-to-Noise Rallo
Ref. 94 dB SPL at I kHz
I
Cardioid
DyNmlc
Range
I kO load,
@
I kHz
96dB
Common Mode Rejection
10Hz to 100kHz
45 dB, minimum
166d8
68d8
P-mpllfter Output Clipping Level
at 1% THO
-35d8V/Pa(18 mV)
-34 d8V/Pa(21 mV)
124d8
123d8
28d8SPL
27dBSPL
-6
dBV (0.5 V)
Polarity
Positive sound pressure on ciaphragm
produces poeitive
vOltage on pin 2 relative to pin 3 of output XLR oonnector
Mute Switch
MX412S/ MX41 BS
-so
dBminimum
Env~leondmona
Operating Temperature
Storage Temperature
Relative Humidity
Power Requlrementa
11-52 V DC, 2.0 mA
-1~s1•c (o-135°F)
-29-74•C (-2o-16S•F)
o-95%
----~-------~--
Shock Mount
1. Drill a 44mm(1-3/4 in.) diameter hole in
desired mounting surface.
2. Mark and drill starter holes for screws,
using shock mount as a template.
3. Secure shock mount to mounting surface
with screws.
4. Thread the supplied adapter onto the
MX400SE microphphone before inserting
it into the shock mount.
Certifications
Meets essential requirements of all applicable
European Directives.
Eligible for CE marking.
The CE Declaration of Conformity
can
be obtained
from Shure Incorporated or any of its European
representatives. For contact information please visit
www.shure.com
The CE Declaration of Conformity
can
be obtained
from: www.shure.com/europe/compliance
Authorized European representative:
Shure Europe GmbH
Headquarters Europe, Middle East & Africa
Department: EMEA Approval
Jakob-OieHenbacher-Str. 12
75031 Epplngen, Germany
Phone: 49-7262-92 49 0
Fax: 49-7262-92 49 11 4
Email: EMEAaupporl@shure.de