Permanent Installation; Specifications - Shure MICROFLEX MX400 Series User Manual

Permanent Installation
Mount the microphone using one of the following methods.
-~·
Flange
1. Drill a 22 mm (7/8 in.) diameter hole in the
desired location.
2. Trace and drill three starter holes for the
supplied screws using the flange as a template.
3. Insert the preamplifier through the mounting
flange.
4. Slip the mounting flange retaining ring over the
bottom of the preamplifier and slide it up until it
is flush to the bottom of the flange. Then press
the ring firmly into place.
5. Secure the flange to the mounting surface with
three screws.
Shock Mount
1. Drill a 44mm(1-3/4 in.) diameter hole in
desired mounting surface.
2. Mark and drill starter holes for screws,
using shock mount as a template.
3. Secure shock mount to mounting surface
with screws.
4. Thread the supplied adapter onto the
MX400SE microphphone before inserting
it into the shock mount.
Specifications Certifications
Cartridge Type
Electret Condenser
Frequency Response
50-17000 Hz
Polar Pattern
MX412/C, MX418/C
MX412/S, MX418/S
Output Impedance
1800
Output Configuration
Active Balanced
Sensitivity
@
1 kHz, open circuit voltage
Cardioid
Supercardioid
1 Pa:94 dB SPL
MaximumSPL
1 kHz at 1% THO, 1 kO
load
Cardioid
Supercardioid
Equivalent Output Noise
A-weighted
Cardioid
Supercardioid
Cardioid
Supercardioid
-35 dBV/Pa(18 mV)
-34 dBV/Pa(21 mV)
124dB
123 dB
28dB SPL
27 dB SPL
Signal-to-Noise Ratio
Ref. 94
dB
SPl at 1 kHz
Cardioid
Supercardioid
Dynamic Range
1 kO load,
@
1 kHz
96 dB
Common Mode Rejection
10Hz to 100kHz
45 dB, minimum
Preamplifier Output Clipping Level
at 1%
THO
--6 dBV (0.5 V)
Polarity
Positive sound pressure on diaphragm produces positive
voltage on pin 2 relative to pin 3 of output XLR connector
Mute Switch
MX412S/MX418S
-50 dBminimum
Environmental Conditions
Operating Temperature
Storage Temperature
Relative Humidity
Power Requirements
11-52 V DC, 2.0 rnA
-18-57"C (0-135°F)
-29-74°C (-20-165°F)
0-95%
Meets essential requirements of all applicable
European Directives.
Eligible forCE marking.
The CE Declaration of Conformity can be obtained
from Shure Incorporated or any of its European
representatives. For contact information please visit
www.shure.com
The CE Declaration of Conformity can be obtained
from: www.shure.com/europe/compliance
Authorized European representative·
Shure Europe GmbH
Headquarters Europe, Middle East & Africa
Department: EMEA Approval
Jakob-Dieffenbacher-Str. 12
75031 Eppingen, Germany
Phone: 49-7262-92 49 0
Fax: 49-7262-92 49 11 4
Email: EMEAsupport@shure.de