Permanent Installation; Shock Mount; Specifications - Shure Legendary Performance MX412 User Manual

Permanent Installation

Mount the microphone using one of the following methods.
flange
retaining ring

Specifications

Cartridge Type
Electret Condenser
Frequency Response
50–17000 Hz
Polar Pattern
MX412/C, MX418/C
MX412/S, MX418/S
Output Impedance
180 Ω
Output Configuration
Active Balanced
Sensitivity
@ 1 kHz, open circuit voltage
Cardioid
Supercardioid
1 Pa=94 dB SPL
Maximum SPL
1 kHz at 1% THD, 1 kΩ load
Cardioid
Supercardioid
Equivalent Output Noise
A-weighted
Cardioid
Supercardioid
4
Flange
1. Drill a 22 mm (7/8 in.) diameter hole in the
desired location.
2. Trace and drill three starter holes for the
supplied screws using the flange as a template.
3. Insert the preamplifier through the mounting
flange.
4. Slip the mounting flange retaining ring over the
bottom of the preamplifier and slide it up until it
is flush to the bottom of the flange. Then press
the ring firmly into place.
5. Secure the flange to the mounting surface with
three screws.
Signal-to-Noise Ratio
Ref. 94 dB SPL at 1 kHz
Cardioid
Supercardioid
Cardioid
Dynamic Range
Supercardioid
1 kΩ load, @ 1 kHz
96 dB
Common Mode Rejection
10 Hz to 100 kHz
45 dB, minimum
Preamplifier Output Clipping Level
at 1% THD
–6 dBV (0.5 V)
Polarity
–35 dBV/Pa(18 mV)
Positive sound pressure on diaphragm produces positive
–34 dBV/Pa(21 mV)
voltage on pin 2 relative to pin 3 of output XLR connector
Mute Switch
MX412S/MX418S
–50 dBminimum
Environmental Conditions
Operating Temperature
124 dB
Storage Temperature
123 dB
Relative Humidity
Power Requirements
11–52 V DC, 2.0 mA
28 dB SPL
27 dB SPL
Certifications
Meets essential requirements of all applicable
European Directives.
Eligible for CE marking.
66 dB
The CE Declaration of Conformity can be obtained
68 dB
from Shure Incorporated or any of its European
representatives. For contact information please visit
www.shure.com
The CE Declaration of Conformity can be obtained
from: www.shure.com/europe/compliance
Authorized European representative:
Shure Europe GmbH
Headquarters Europe, Middle East & Africa
Department: EMEA Approval
Jakob-Dieffenbacher-Str. 12
75031 Eppingen, Germany
Phone: 49-7262-92 49 0
Fax: 49-7262-92 49 11 4
Email: EMEAsupport@shure.de
–18–57°C (0–135°F)
–29–74°C (–20–165°F)
0–95%

Shock Mount

1. Drill a 44mm(1-3/4 in.) diameter hole in
desired mounting surface.
2. Mark and drill starter holes for screws,
using shock mount as a template.
3. Secure shock mount to mounting surface
with screws.
4. Thread the supplied adapter onto the
MX400SE microphphone before inserting
it into the shock mount.