The Snmp Page - Linksys Instant EtherFast EPSX3 User Manual

The SNMP Page

Click the SNMP tab to view or change the PrintServer's SNMP settings.
The Print Server supports SNMP (Simple Network Management Protocol).
This allows network supervisors to monitor and control the Print Server using
network management platforms such as HP OpenView, IBM SystemView, etc.
The appropriate MIB file must be imported into your SNMP management pro-
gram using the Import-Compile command. Check your management program
for details on this procedure. The MIB file is provided in the Mib folder on the
CD-ROM. The name of the file is Mib2p.mib.
General
SysContact Text Field - Name of the contact person.
SysLocation Text Field - Location of the contact person.
Note: Linksys does not provide technical support for SNMP man-
agement.
32
Instant EtherFast
Figure 8-5
EtherFast 10/100 PrintServers
® Series
Management Stations
Station No. Select the Management station (1-4) and click the Get Data but-
ton to update the display for the selected item.
IP Address Enter the management station's IP Address, which has the SNMP
program installed.
Community This is a text field. Enter the name of the community, normally
public or private.
Access Select the desired level of access, Read-only, Read-Write, or Not
Accessible.
Trap Receivers
Receiver No. Select the Trap Receiver number (1-4)-and click the Get Data
button to update the display for the selected item.
IP Address Enter the Trap Receiver's IP Address, where the Trap message will
be sent.
Community This is a text field. Enter the name of the community, normally
public or private.
Enable Check to enable; select the severity level. By default, all traps are level
one.
If you make any mistakes, click the Cancel button, to exit the screen without
making any changes. Once you are certain of any changes you have made,
click the Save button to implement the changes.
33