Linksys EFSP42 ver. 2 Quick Installation

M a k i n g C o n n e c t i v i t y E a s i e r
Instant EtherFast
EtherFast
PrintServers
Model No.: EFSP42 ver. 2, EPSX3, PPSX1
Overview
Overview
After installing the PrinServer hardware onto your network,
you will need to install the PrintServer Driver software. For
information on hardware installation or if you experience any
difficulty, refer to your User Guide.
N N o o t t e e : To set up DHCP on the PrintServer, install B B i i - - A A d d m m i i n n first (see
page 37 of the User Guide), then install D D H H C C P P (see page 57 of the
User Guide), then proceed to install the Printer Driver.
W indows Driver Setup
W indows Driver Setup
1. Click on Start, Run, and enter
D:\Driver\Win9xnt\Setup.exe. Click OK.
2. The Install Wizard window appears. Click Next.
QI-EFSP42v2-10720A DG
™
® Series
® 10/100

Quick Installation

For All Windows Operating Systems
This sheet will guide you through the basic steps needed to install any
of the EtherFast ® 10/100 PrintServers onto your network. If you have
any problems during installation, refer to the Troubleshooting section
of the User Guide.
3. Click Next to accept the Destination Directory default,
shown below.
4. The Select Components window appears. If your computer
is the network administrator's computer, check Install
TCP/IP Setup Program (System Administrator only).
Otherwise, select the default, Install Linksys PrintServer
Driver. Click Next.
Continued on back...